Refill Instructions

Epson T060, T069, T078, T079, T098, T125 Refillable Cartridges

1. Put the cartridge on some paper towels in an area where you can tolerate a spill.

2. Remove the Filling Hole Plug and the Vent Hole Plug.

3. Fill syringe with ink. (the cartridge will take approximately 14ml)

4. Insert the needle into the Filling Hole.

5. Very Slowly inject ink into the cartridge. Leave a small air space at the top of the cartridge.

6. Replace the Filling Hole Plug. (Important - Leave the vent plug out)

7. Leave the Vent Hole Plug out if you are going to put the cartridge into the printer. If you are going to save the filled cartridge for use at a later date then put the Vent Hole Plug back in. The Vent Hole Plug is only used for storing the cartridge for later use. When putting the cartridge into the printer be sure to remove the Vent Hole Plug. If you don't do this, the cartridge will not print.

8. Install the cartridge into the printer and run 1 - 3 cleaning cycles as per printer instructions.
Or print the following pages:
http://www.refillinstructions.com/black.htm for Black
http://www.refillinstructions.com/color.htm for Color 

   When the printer indicates that the cartridge is running low on ink. Remove the cartridge, fill with ink, and reinsert the cartridge back into the printer. This will reset the chip back to full. The chip is reset back to full when power if removed from the chip (such as taking it out of the printer) and then reapplying power to the chip (such as putting it back into the printer after the refill). If you have a power failure at your house or your printer is unplugged and then power comes back on you might have your cartridges resetting themselves back to full.
   Many users find it more convenient to have two sets of cartridges to precipitate a quick change over when a cartridge is reported empty.