Lexmark / 18C0781 #1

COLOR CARTRIDGE

1. Put the cartridge on some paper towels in an area where you can tolerate a spill.

2. Peal off the top label.

3. Fill the syringe with 7 ml. of color ink.

4. Very S-L-O-W-L-Y inject ink into each chamber until the sponge is full. A little ink might come out of the top when full, so cover up the other two holes while filling one.

5. When finished, replace the top label or leave it off (it will make no difference in the printing).

6. Replace the cartridge and run 1 - 3 cleaning cycles as per printer instructions.
Or print the following pages:
http://www.refillinstructions.com/color.htm for Color 

If necessary leave cartridge in printer for up to 8 hours.

The cartridge will print just like a new one. Even though the cartridge prints good, the ink level gauge will not read full after a refill.

Note: Some of the newer Lexmark cartridges have very small holes and the needle will not fit into it. In that case just use the thumb drill provided and drill the holes larger.

A Refill Kit should include
Ink plus the following:
Three 10cc Syringes
One Thumb Drill

www.PrinterFillingStation.com
Printer ink and Refill kits for your Printer