Lexmark / 18C0190 #2

COLOR CARTRIDGE

1. Put the cartridge on some paper towels in an area where you can tolerate a spill.

2. Peal off the top label.

3. Follow the canal trace from the edge of the label to the very small hole at the end of the canal. This hole is big enough for a human hair to go through but not a syringe needle.

4. Drill all three holes (cyan, magenta, and yellow) larger with the thumb drill provided.

5. Fill the syringe with 7 ml. of color ink.

6. Very S-L-O-W-L-Y inject ink into each chamber until the sponge is full. A little ink might come out of the top when full, so cover up the other two holes while filling one.

7. When finished, replace the top label or leave it off (it will make no difference in the printing).

8. Replace the cartridge and run 1 - 3 cleaning cycles as per printer instructions.
Or print the following pages:
http://www.refillinstructions.com/color.htm for Color 

If necessary leave cartridge in printer for up to 8 hours.

The cartridge will print just like a new one. Even though the cartridge prints good, the ink level gauge will not read full after a refill.

A Refill Kit should include Ink plus the following:
Three 10cc Syringes
Thumb Drill

www.PrinterFillingStation.com
Printer ink and Refill kits for your Printer