Refill Instructions
Sharp UX-22BC Black Cartridge
and others from Lexmark, Compaq, Xerox, and others.

The ink in this cartridge is retained because the cartridge has an internal sponge.

BLACK
1. Make a hole in the top of the cartridge using the 1/16" thumb
drill provided. (Do not remove the top.)
2. Fill the syringe with 12-25 ml. of ink, insert the
needle into the vent hole and push down into the center of the cartridge. Slowly inject up
to 25ml. of black ink into the cartridge.
3. Set above a paper towel for half an hour as a drip precaution.
Expect a few drips. Do not allow the cartridge to touch the paper towel at this point,
since the towel will draw out the ink.
4. Replace the cartridge and run 1 - 3 cleaning cycles as
per printer instructions.
Or print the following pages:
http://www.refillinstructions.com/black.htm
for Black
For best results, leave cartridge in printer for 8 hours after refilling so the ink can saturate the entire sponge. (Allows ink to flow to the
print head).
Empty cartridges should be refilled immediately.
Also this work is done best over the sink.
A Refill Kit should include Ink plus
the following:
1 Syringe
1 Thumb Drill

www.PrinterFillingStation.com
Printer ink and Refill kits for your Printer |